Short answer: switch the sauna on, open Bluetooth in your phone's settings and tap the sauna when it shows up as iSauna, BT100 or Bluetooth. Only one device can be connected at a time. If it won't pair, unplug the sauna's power cord for 15 minutes to reset the audio system. The steps below follow Dynamic's owner's manuals and apply to the Dynamic infrared saunas that have built-in Bluetooth speakers.
How to connect Bluetooth in a Dynamic sauna
- Power the sauna on. Plug it in and turn it on at the control panel.
- Open Bluetooth on your phone or tablet. Go to Settings, then Bluetooth, and leave the menu open while it searches.
- Pick the sauna. Depending on the model and year, it appears as
iSauna,BT100or simplyBluetooth. Tap it to pair. - Play something. Once your phone shows it as connected, audio from any app plays through the sauna's speakers. Set the volume and choose music on your phone.
Good to know
- One device at a time: the sauna pairs with a single device. Disconnect or unpair the current phone before connecting another one.
- Using the AUX (MP3) jack: some models have an MP3 jack in the ceiling. Disconnect Bluetooth first, then plug the AUX wire into the jack and your device. When you unplug the wire, the sound system switches back to Bluetooth on its own.
- Don't leave the AUX wire hanging: a wire plugged into the ceiling jack with nothing on the other end causes constant static. Unplug it when you're not using it.
- Keep your phone outside: phones aren't built for sauna heat and can overheat or shut down. Leave it just outside the door, within Bluetooth range (often around 30 feet in open air, less through walls). Our guide to bringing your phone into a sauna explains why.
Troubleshooting Bluetooth problems
| Problem | What to try |
|---|---|
| The sauna doesn't show up on my phone | Check the sauna is powered on and your phone is close by. Make sure no other device is already connected to it. If it still doesn't appear, do a master reset: unplug the sauna's power cord from the wall for 15 minutes, then plug it back in. |
| I can't connect a second phone | Only one device can connect at a time. Unpair or switch off Bluetooth on the first phone, then pair the new one. |
| Static from the speakers when nothing is playing | Check the AUX wire isn't plugged into the ceiling jack. A half-connected AUX wire causes constant noise. |
| Humming while Bluetooth is connected | Play the same music through the AUX wire instead. If the hum disappears on AUX, Dynamic's manuals say the control panel is the likely cause and needs replacing, so contact us for help. |
| Sound cuts in and out | Move the phone closer to the sauna and away from other wireless gear, or disconnect and pair again. |
| It was working and suddenly stopped | Do the 15-minute master reset above, then pair again. Forgetting the sauna in your phone's Bluetooth list before re-pairing can help. |
For heaters, lights and control panel issues, see our Dynamic sauna troubleshooting guide. The exact steps for your model are in its manual on our Dynamic owner's manuals page.
Still not working?
If the reset doesn't fix it, or you hear a hum that only goes away on AUX, contact our support team with your sauna's model number (on the label or in the manual) and a short description of what happens. We'll help you work out whether it's a setting or a part.




